Wednesday, 20 November 2019

Christmas Wishes Tutorial

Hi Everyone, thanks for stopping by. Today I am sharing a card tutorial for you try. I hope you enjoy it. Although there are a few steps to this card, don't worry it's not difficult.


Supplies: 
Stamp Sets – Tidings All Around Stamp Set (150465); Toile Christmas Stamp Set (150469)
Card Stock – Real Red Card Stock (102482); Crumb Cake Card Stock (120953); Very Vanilla Card Stock (101650)
Stamp Pads – Real Red Ink (147084); Garden Green Ink (147089)
Misc. – Toile Tidings Designer Series Paper (DSP) (150432); Real Red 1” Ruched Ribbon (150435); Christmas Cardinal Dies (150640); All-Around Wreath Dies (150641); Brick & Mortar 3D Embossing Folder (149643); Red Rhinestone Basic Jewels (146924); Mini Stampin’ Dimensionals (144108); Mini Glue Dots (103683); Multipurpose Glue (110755)
Measurements:  
Real Red Card Stock:         8 1/2” x 5 1/2” 3 1/4” x 1-1/4”
Crumb Cake Card Stock: 4” x 5 1/4” 
Very Vanilla Card Stock: 3 3/4” x 3 3/4” 3 1/4” x 1 1/4”
Toile Tidings DSP: 4” x 1 1/2”
Real Red 1” Ruched Ribbon:         6”         15” (bow)
 
Instructions:
1. Fold the larger Real Red piece in half to form the card base. 
2. Emboss the Crumb Cake piece with the Brick & Mortar 3D Embossing Folder. 
3. Attach the DSP piece across the top of the Crumb Cake piece. 
4. Wrap the 6” piece of ribbon across the bottom edge of the DSP, and attach the ribbon ends to              the back of the Crumb Cake piece. Attach the piece to the card base.
5. Stamp the wreath stamp from the Tidings All Around Stamp Set onto the larger Very Vanilla                piece using Garden Green Ink. 
6. Die-cut the wreath out with the wreath die from the All-Around Wreath Dies. Attach it to the              bottom, center of the card with Mini Stampin’ Dimensionals. 
7. Attach Red Rhinestones randomly around the wreath.
8. Tie the 15” piece of ribbon into a bow, and attach it to the middle of the attached ribbon using              two or three Mini Glue Dots. Trim the ribbon ends at an angle.
9. Stamp the “Christmas Wishes” banner stamp from the Toile Christmas Stamp Set onto the                  smaller Very Vanilla piece using Real Red ink. 
10. Die-cut it out with the single-banner die from the Christmas Cardinal Dies. 
11. Die-cut another banner from the smaller Real Red piece. 
12. Attach the stamped banner on top of the Real Red banner, letting a little of the Real Red banner          show from the top.
13. Attach the banner across the center of the wreath with Mini Stampin’ Dimensionals.



Three Days ONLY

Are you ready to save some money?  For three days only you can save 15% off selected card stock, ink pads and bundles! It starts tomorrow! Click here for all the details